This
week, the team had talked to the software development team regarding to the algorithm
of position sensing. After the discussion, the team decided to use the station
ID as one of the reference for position sensor. However, after meeting with the
software development team, the team also found we need to have reference for position
sensing after track switching, and the issue will be discussed with the control
team about the magnet and sensor they will be using.
The
team gathered and came up with a design on the holder for the sensor with the
new magnet. However, the CAD drawing was not able to be completed in this week
after the team spending significant amount of time on designing a proper
holder.
Since
November is ending, the team will arrange more meetings at the end of the 3rd
week if November and the 4th week because of the holidays.
Hopefully, the sensor holder will be completely built.
The
team like to test the sensors on a piece of corrugated sheet metal with fine
corrugations. However, the corrugated sheet metal is not arriving and the
website does not provide any tracking resources. The sheet metal will be cut in
to strip and tested after its arrival.
No comments:
Post a Comment